1L

1L free consultation Tolerances Rigidity ± 10% Free length ± 1%, with a minimum of ± mm 0.75 (this tolerance is less than that prescribed by the ISO standard). Outer diameter the outer diameter of the spring is always smaller than the housing diameter given in the catalog Inner diameter the inner diameter of the […]

1S

If you decide to use a passage from Lorem Ipsum, be sure that it does not contain anything embarrassing. Generally, placeholder text generators available on the Internet tend to repeat predefined paragraphs.

2S

2S Tolerances Rigidity ± 10% Free length ± 1%, with a minimum of ± mm 0.75 (this tolerance is less than that prescribed by the ISO standard). Outer diameter the outer diameter of the spring is always smaller than the housing diameter given in the catalog Inner diameter the inner diameter of the spring is […]

3S

3S Tolerances Rigidity ± 10% Free length ± 1%, with a minimum of ± mm 0.75 (this tolerance is less than that prescribed by the ISO standard). Outer diameter the outer diameter of the spring is always smaller than the housing diameter given in the catalog Inner diameter the inner diameter of the spring is […]

4S

4S Tolerances Rigidity ± 10% Free length ± 1%, with a minimum of ± mm 0.75 (this tolerance is less than that prescribed by the ISO standard). Outer diameter the outer diameter of the spring is always smaller than the housing diameter given in the catalog Inner diameter the inner diameter of the spring is […]

5S

5S Tolerances Rigidity ± 10% Free length ± 1%, with a minimum of ± mm 0.75 (this tolerance is less than that prescribed by the ISO standard). Outer diameter the outer diameter of the spring is always smaller than the housing diameter given in the catalog Inner diameter the inner diameter of the spring is […]